One channel input module for conversion from standard analog signals to ModbusRTU
It can be used for the conversion of standard unipolar voltage and current signals and to supply 2-wire transmitters
All parameters can be set through the Modbus RTU interface by means of a mini USB port for programming located on the front of the module
The software configuration, free from Drago website, for PC offers various options and diagnostic functions
The more general settings can be made using the dipswitches
The measured value can be read out via the Modbus RTU interface (RS485)
One input 0...20 mA, 4...20mA, 0...10V, 2...10V, 1...5V, 2...5V
Output: Modbus RTU protocol (RS485), up to 247 measurement inputs in one Modbus segment
2-way isolation is 3 kV AC, 50 Hz, 1 min
The auxiliary power supply and the RTU Modbus can be connected to the connection terminals on the module or through the In-Rail-Bus connector on the back of the card
Module size: 6,2mm